Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

IPC-TM-650, does it apply?

Views: 1353


IPC-TM-650, does it apply? | 7 February, 2014

TM-650 specifies a 50mm (2in) length of tape to be used for the test. What about areas that are smaller than 50mm? For example component pads surrounded by open areas are much smaller than that as are vias. If they pull off using the tape test would that constitute a failure?


reply »


IPC-TM-650, does it apply? | 16 February, 2014

IPC-4552 says it does. It specifically talks about ball grid array (BGA) pads so small feature size is included as valid.


reply »

bga rework stations

PCB X-Ray Inspection System