Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Mirae 1010 problem

Views: 918


RLM

#71335

Mirae 1010 problem | 6 November, 2013

I have a Mirae 1010 and am getting the message "FPGA 1 bad or illegal" upon initilization. Has anyone ever come across this message ? If I reboot several times I can get the machine started.

Thanks

reply »

#71337

Mirae 1010 problem | 6 November, 2013

The key to figuring out mirae machine failures 'most of the time' is found in mr-terminal. Is this message from mr-terminal or is this the windows/program software error. Mirae 1010 machines have boot failure problems often. Sometimes if the z position of the heads is not the correct height (meaning too high or low) it wont boot. Also if the gantries are not located in a certain area of the machine they will not boot. Just some food for thought.

Good Luck

reply »


RLM

#71340

Mirae 1010 problem | 6 November, 2013

Thanks Bob,

Any idea on how to switch between the front & back monitor/keyboard. This machine doesn't have a front/back switch like my other one. i am guessing that there is a keyboard sequence that i need to hit.

reply »

#71343

Mirae 1010 problem | 7 November, 2013

I believe but am not 100% sure on this but usually just hitting any key will change which monitor/keyboard is being used. I know for sure on the newer models it works this way. There should be a hub in the machine where keyboards/mouse/monitors run to.

reply »

SMT Custom Nozzles

Software for SMT