Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Swapping heads between Samsung CP40's

Views: 3209

#68092

Swapping heads between Samsung CP40's | 4 February, 2013

I do basic machine maintenance, have been asked to look into swapping out heads between two older Samsung CP40 machines. I have said that attempting this is not advisable for the following reasons: * I do not have access to Samsung Technical support

* We do not have any calibration fixtures for the machines

* The only manuals that we have are the basic operator manuals

I am just looking for a second opinion, thanks

reply »

#68181

Swapping heads between Samsung CP40's | 12 February, 2013

Dave,

It depends on what you mean by swapping heads. If you want to move the aligners its not too hard. If you want to move the entire head assy it will require a lot of calibration. Anything can be done but it really about the cost and the value of the machines. If you can give me some more details I can be more helpful. if you are an owner as opposed to a reseller of the machines I am willing to help. Give me a call

Larry 267-374-8173

reply »

#71251

Swapping heads between Samsung CP40's | 17 October, 2013

Hi Larry,

I have a machine where one head has a faulty Z servomotor, and another head has a defective aligner.

In the meantime that I procure the required spare parts, what part is easier to swap in order to have at least one head productive?

Eventually, in case, can You supply me the suitable spare parts and the appropriate calibration procedure ?

Thanks

reply »

#71268

Swapping heads between Samsung CP40's | 22 October, 2013

move the aligner. they are pinned and will likely work without calibration. Yes I sell parts and service. give me a call I have an e copy of the service manual

reply »

#71269

Swapping heads between Samsung CP40's | 23 October, 2013

Many thanks Larry, I contact You asap.

reply »

#71274

Swapping heads between Samsung CP40's | 23 October, 2013

You can contact the service team directly at service.sctai@samsung.com in regards to your CP40 support.

reply »

SMT Custom Nozzles

Plasma prior Conformal Coating