Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

Heller Oven

Views: 1123


Heller Oven | 18 October, 2012

Does anyone know if there is a way to adjust the tolerances in the software to decrease the temperate window that the cells will turn green on Heller's V1.0.xx software (running on a 1800)?

reply »


Heller Oven | 19 October, 2012

Hi Phil ... Here's a response from Heller Industries ...

If I understand correctly you want to tight the tolerance window between set point and present value. Actually you can do so by lower down the warning band to 5C which is default 15C. Please make sure that we don’t recommend below 5C and below are instructions to access channel setup.

2. Choose Channel setup from the Window menu. Select the Heat zone channel in question using arrow key. (A typical channel screen for a heat zone is shown in below figure

Best regards,

Bilal Malhi Manager Heller Global Service Center 4 Vreeland Road Florham Park, NJ 07932 Phone: 973-377-6800 Ext. 312 Fax: 973-660-2058 Web:

All spare part orders will require the model and serial number of the oven. Price quote is valid for 30 days. Minimum order amount is $50.00. Cancelled orders will incur a 25% restocking fee for standard parts and a 40% restocking fee for specialty parts.


reply »

Reflow Oven

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域