Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Dek 265

Views: 2796

#67336

Dek 265 | 22 September, 2012

Dek265 Upward vision is dim. Replaced bulb. Vision is still to dark to see anything. Bottom you can see fine. Any ideas?

reply »

#67337

Dek 265 | 22 September, 2012

You don't say which 265; presumbly since you say "bulb" it is either MK1 or GS with shuttered camera. Both those machines have potentiometers to control light levels. MK1 is on machine frame inside drop down (stencil load) door, near serial tag. GS is on far right side with front top cover lifted.

Contact me directly for additional assistance.

http://dekhead.com

reply »

#67358

Dek 265 | 26 September, 2012

The bulb is bright but nothing shows on the screen. It will not see anything above it. If I put an LED by it the light shows on the monitor. Any ideas?

reply »

#67359

Dek 265 | 26 September, 2012

Also I adjusted the pot it is all the way up.

reply »

 Reflow System

PCB machines