Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Assembleon Eclipse error: L006: Tr.over current

Views: 2431

#67305

Assembleon Eclipse error: L006: Tr.over current | 19 September, 2012

Hello alltogether

we have some old assembleon mashines here in hungary. Since some days we are fighting with our Eclipse. After started if we push the ready button appear the error code : L006:Tr.over current. Does anyone know what is Tr. ? Is this the transformator ? How can we solve the problem ? We would be very thankfull for any help or idear how to find this bug.

regards Ekkehart

reply »

#67327

Assembleon Eclipse error: L006: Tr.over current | 20 September, 2012

This error occurred in machines built before 1996 due to interference only. On later machines if it ocurrs when the servo is turned on then too much current have flowed through the IPM module on the Driver Board. You should check:/ 1/.. The pins on the MO1->4 connectors because the pins push back ! 2/.. Check mechanical freedom of each axis. With power off.. feel each motor rotation for a burnt armature. 3/.. Replace the Driver Board.

reply »

#67439

Assembleon Eclipse error: L006: Tr.over current | 4 October, 2012

Hallo Jeff

thanks a lot for your answer. Yes the error was the bad driverboard. The daughterboard AC . We changed and the mashine is running. Unfortunately we have now a problem with the Handheldkeyboard.The joystick is not working. The same problem is on our Comet. No joystick function. Do you have one more idear ?

thanks in advance Ekkehart

reply »

#67441

Assembleon Eclipse error: L006: Tr.over current | 4 October, 2012

Are you saying that the buttons on the Joystick work, but the Joystick lever for XY is not working?

reply »

#67450

Simulator for the Eclipse | 7 October, 2012

Hi Jeff

we opend the HHK and removed the Eprom . We reed out and put it back. After that I dont know why it worked .

By the way: we have a simulation program for our Saphire where we can prepare programs . Did you ever heared of a simulator for the Eclipse ? It would be very helpful to use it .

thanks in advance Ekkehart

reply »

SMT Custom Nozzles

SMT in-printer dispensing