Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


vitronics delta wave malfunction errors :pcb expected at exit

Views: 2067

#67253

vitronics delta wave malfunction errors :pcb expected at exit | 14 September, 2012

Hello!I have a delta wave with these problems:offtime of lambda wave tracking is too long and when modify offtime setting to a negative value for a fast stop on tracking position of lambda wave, the wave pass on stand-by with a delay of half of leght of pallet every time.Ontime of lamba wave on tracking is working fine.I noticed the same delay occurs and the nozzle off fluxer.Offtime modifies nozzle fluxer, fluxing stops faster, but after a short time later turns fluxing although OnTime nozlle fluxer value remained the same.Pcb expected error appears at exit.I cleaned and checked the input and output sensors. In debug mode on rack0 at S5 position i checked if he sees palette entry and exit.Receives commands but random tick boxes and uncheck 2-3 times per second.I need some help!Thank you!

reply »

#67257

vitronics delta wave malfunction errors :pcb expected at exit | 14 September, 2012

Hi,

Recently we acquired a Delta 3 and I noticed everytime we change any value regarding to the tracking system, as chip or main wave - offtime/ontime- with boards loaded on it, the tracking system doesnt work well. sometimes it turns off the wave or chip in the half of board, sometimes it doesn't turn on... I noticed that when we change any of these values regarding to tracking system with the machine empty, it works well, but with the machine loaded, it doesnt work.

reply »

#67259

vitronics delta wave malfunction errors :pcb expected at exit | 14 September, 2012

In Setup menu there is a last option Debug. Debug choosing a window with Rack0, Rack1, Rack2, Rack3, log RS485 opens. Choosing rack0 a window with parameters S3 boxes 1 to 12 Input and certain boxes are checked, S4 Output from 1-8, from 1-8 S5 Output. if you get your hands on sensor input automatically tick the boxes 1, 2 and 3. I guess from the sensor show command. if you get 2 or more pallets 1,2,3 tick boxes and uncheck automatically but in a very short time under a second. I guess a motherboard is faulty command.A circuit of delta wave 3 would be helpful to see where they go from sensor input controls, output

reply »

#67447

vitronics delta wave malfunction errors :pcb expected at exit | 5 October, 2012

another delta wave have the same fault, same symptoms!!!

reply »

PCB machines

PCB equipment