Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


DEK 265 wrong board alignment

Views: 2014


Fox

#67080

DEK 265 wrong board alignment | 23 August, 2012

Hi!

We have a dek 265 gsx printer. And we have a problem with it. After determination of fidutials it puts the paste differently. Sometimes it puts senterline, sometimes left of center and right of center. We can't identify the problem. Could you please tell us what is the problem? Thank you in advance!

reply »

#67081

DEK 265 wrong board alignment | 23 August, 2012

There are a couple of things that I would check. Check the board clamps and make sure that they're in good shape and that they're actually holding the board securely. If those check out I would take a look at the fid camera and make sure that everything is tight, and last you can check to make sure that the stencil is being clamped tightly.

I'm sure there are some other culprits you could check, but this is just what comes to mind for me.

-Phil

reply »

#67221

DEK 265 wrong board alignment | 7 September, 2012

Run the calibration screen/procedure. I have had where the camera was hit etc.. and caused a misalligned print.

reply »

Used PCBA Equipment