Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Omniflo 7 task timeout error

Views: 678

#66930

Omniflo 7 task timeout error | 1 August, 2012

ERROR: "The specified i/o operation on DeviceHarddisk0Partition01 was not completed before the timeout period expired"

This is followed by out of control conveyor speed and zone temps.

Oven recovers when the error is acknowledged. This is happening about once a week. Is there a simple solution or am I looking at a potential hard drive or controller interface failure??

reply »

SMT Replacement Nozzles