Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


ip3 mtu

Views: 2365

#65442

ip3 mtu | 14 November, 2011

SZ SENSOR WENT OFF DURING SY AXIS MOVEMENT. WHAT WOULD BE THE RIGHT WAY TO FIX PROPER IS OFF.DONT HAVE ORIGINAL PROPER .

reply »

#65444

ip3 mtu | 15 November, 2011

You will need to be more specific than that. What do you mean it went off ?

reply »

#65445

ip3 mtu | 15 November, 2011

Well try to run in idle n as soon as the mtu. Goes to pick up part on tray it goes down but when homing back in position doesnt flag sensor because position is off.so the sz sensor not bieng flaged. Any ideas

reply »

#65446

ip3 mtu | 15 November, 2011

Seems odd that the machine would zero set if there was a sensor not being made.

reply »

#65449

ip3 mtu | 15 November, 2011

Do you have any trays in the location you are trying to pick from? The Z axis should move until it detects the top of a tray. Without any trays it may not function correctly. Also some machines will need an empty tray below the tray you want to pick from.

Jerry

reply »

#65451

ip3 mtu | 15 November, 2011

Thats the odd part that i can zero set no problem just when i try to run idle the sz sensor ok when goes down but when it goes back up its not bieng retracted up so sensor stays off n eror acurs again any ideas.

reply »

Essemtec Spider SMT Fluid Dispenser

Large PCB Dispensing System