Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Quad IVC Motor Error 4

Views: 1735


Jay

#64580

Quad IVC Motor Error 4 | 30 June, 2011

I am seeing a motor error 4 intermittently during operation. Sometimes it happens as soon as a program starts, sometimes it will perform 1-6 placements and then stop with it. I have swapped the stepper motor driver cards, the EPCU card, the SRX card with known good cards and still have the error. I have checked the motor cables and windings and don't seem to have a problem there. Anyone had this problem or seen one similar to it?

reply »

#64581

Quad IVC Motor Error 4 | 30 June, 2011

x and y ribbon cables would be my first guess......

good luck

reply »


Jay

#64592

Quad IVC Motor Error 4 | 6 July, 2011

bought the cable replacement kit and replaced all of the ribbon cables and still the deadly motor error 4. Everything in the system has been replaced except the X motor and the Y motor cable.

reply »

#64593

Quad IVC Motor Error 4 | 6 July, 2011

i have seen bad motor cables cause the problem......you can ohm them out to the driver cards or if you have extras....replace them

Bob

reply »

SMT Custom Nozzles

vacuum tweezers - manual pcb assembly