Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Pilarhouse Jade error

Views: 2715

#63554

Pilarhouse Jade error | 18 January, 2011

I recently wrote a program on one of our Pilarhouse Jade machines and receiving an error. The machine has the feature of "Wave Height" that I don't have enabled for a 2.5mm extended tip nozzle. This is the only program that I haven't used this feature. So what it does is this... the first board you run it does the solder bath height check, fluxes board, solders board, and goes home. You load the second board, hit start, it fluxes, then shows a "Reserved" error on the log. You can stop the program, start it, and it will run fine for that one run but when you load another board the error pops up again. I've tought the nozzle for "wave height" and enabled it and it still shows an error.

Any ideas??

reply »

#63561

Pilarhouse Jade error | 19 January, 2011

> I recently wrote a program on one of our > Pilarhouse Jade machines and receiving an error. > The machine has the feature of "Wave Height" that > I don't have enabled for a 2.5mm extended tip > nozzle. This is the only program that I haven't > used this feature. So what it does is this... the > first board you run it does the solder bath > height check, fluxes board, solders board, and > goes home. You load the second board, hit start, > it fluxes, then shows a "Reserved" error on the > log. You can stop the program, start it, and it > will run fine for that one run but when you load > another board the error pops up again. I've > tought the nozzle for "wave height" and enabled > it and it still shows an error. > > Any ideas??

Just re wrote the program exactly with no error. Confused...

reply »

Metcal soldering rework

PCB Routers