Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


What machine would you buy?

Views: 3310


cs

#63520

What machine would you buy? | 14 January, 2011

Hello!

We are looking for new SMD-machines. We can choose between Fuji, Assembléon and Siplace. What machines would you buy??

Christian

reply »

#63522

What machine would you buy? | 14 January, 2011

in my opinion - Fuji - the best choice. Assembleon and Siplace torment you with their software) These machines - a lower level.

reply »

#63532

What machine would you buy? | 15 January, 2011

That’s a pretty general statement. You would need more specifics to make a good choice. The question is like asking what kind of car should I buy Ford, Chevy or Dodge and leaving out Toyota, Honda etc. What are the volumes ? What is the mix ? What models are you looking at ? If buying new why limit your choices to those three manufactures

reply »

#63541

What machine would you buy? | 17 January, 2011

Here is a good site to calculate parts per hour etc...

www.pickandplace.com

reply »

#63542

What machine would you buy? | 17 January, 2011

And Fuji doesn't torment you with software ? Hmmm... Fuji machines are mechanically great. Flexa/F4G/MCS is a pain in the ass unless your techs really know what's goin on.

We are switching from all Fuji to Juki. I won't say anything else about that because people on the forum start getting excited and we don't want that.

reply »

#63543

What machine would you buy? | 17 January, 2011

KhHrpr has it right as far as a starting point. Have to know what you going to be building before selecting the machines that will take you there with the least amount of issues and/or limitations.

SrTech has it right, too. No excitement allowed in the forums!!

reply »

SMT Machines

Electronics Equipment Consignment