Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Feeder Calibration

Views: 3782

#62541

Feeder Calibration | 26 August, 2010

Is there any where to rent feeder calibration equipment?

reply »

#62551

Feeder Calibration | 27 August, 2010

Ok...Maybe there isn't such a place. I am suppossing that everyone purchases from the machine manufacturer. Does anyone know of a third party unit that work well? I would like to be able to get a unit that we allow us to calibrate our siemens and universal on the same base.

reply »

#62588

Feeder Calibration | 1 September, 2010

Hi Namruht, One question, what exactly are you wanting to achieve using "feeder calibration? In what way would feeder calibration make these feeders (between Siemens and Universal) compatible? Or maybe i misunderstood your point .....

reply »

#62593

Feeder Calibration | 1 September, 2010

> Hi Namruht, One question, what exactly are you > wanting to achieve using "feeder calibration? In > what way would feeder calibration make these > feeders (between Siemens and Universal) > compatible? Or maybe i misunderstood your point > .....

I know that there is a inspection jigs for feeder calibration Siemens and Fuji, they may be officially on the manufacturer. But still need staff (with experience).

reply »

#62616

Feeder Calibration | 2 September, 2010

Feeder calibration helps to center the window opening used during component pick-up by a machine nozzle. Once this is established, the next step would be to confirm the centering of Machine nozzle to the center of this feeder window during machine operation. In case you experience a problem during component pick-up, be sure to understand if this is caused by Feeder mis-caibration or by the nozzle off-centering on machine.

reply »

#62733

Feeder Calibration | 18 September, 2010

I know of Ambitec (Taiwan). They make feeder calibration jigs where the base is common for all types of feeders. You just need to replace the jig on the base depending on the feeders you're trying to calibrate. They provide base as well as jigs for mostly all machines such as Yamaha, Fuji, Siemens, Pana, Universal, Juki....

reply »

#62734

Feeder Calibration | 18 September, 2010

"Is there any where to rent feeder calibration equipment?"

I'm not sure, better buy a new one if you have more than 1000 feeders. For six months he paid for himself.

reply »

SMT Custom Nozzles

Large PCB Dispensing System