Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


MPM AP25 problem

Views: 1680

#61801

MPM AP25 problem | 11 May, 2010

Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I have 24VDC coming in, but nothing going out. It also says "if not closed, check for bad Output #0, I/O #3", but I am not sure what it means by "not closed". Any help would be greatly appreciated.

reply »

#61804

MPM AP25 problem | 11 May, 2010

DPR is functioning properly now that I have checked it properly.

reply »

#61860

MPM AP25 problem | 19 May, 2010

did you get the problem fixed or do you still have the problem?

reply »

#61866

MPM AP25 problem | 19 May, 2010

all good now, thanks anyway

reply »

PCB machines

HeatShield Gel- thermal PCB shield during reflow