Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


GSM2 will not zero - Theta1 following error

Views: 1178

#61080

GSM2 will not zero - Theta1 following error | 9 February, 2010

Machine has 2 FlexJets installed. Working fine until it started giving Theta1 following errors. Machine will not zero. Coincidental (I think) with this, the Low Power Power Supply behind the Power Distribution Panel failed and was rebuilt. It's working properly. 12V to heads is fine.

If I dismount Head1 in software the error changes to Theta3. Machine still doesn't zero.

Suggestions?

reply »

#61084

GSM2 will not zero - Theta1 following error | 9 February, 2010

Refer to the thread started by Deni on 2/4/10. Your problem is similar.

reply »

PCB X-Ray Inspection System

SMT Equipment