Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

Feeder maintenance program

Views: 2450


Feeder maintenance program | 13 November, 2009

Hi All, I am implementing a proper feeder maintenance program for my HSP chipshooter feeders. I have the calibration jig.

I am developing a procedure with the following general steps: 1. Cleaning 2. Visual Inspection / Repair 3. Calibration / Testing

What do you do for overall cleaning? I am tempted to go as far as run each feeder head through a non-corrosive ultrasonic cleaning cycle. Then lubricate general areas with dry-film lubricant, and pivot points with grease.

If anyone has insight on how they perform maintenance I would appreciate it.

reply »


Feeder maintenance program | 13 November, 2009

Normaly we clean using tooth brush with anti grease agent. Most of the time we found the eccentric pins got worn out during HSP feeder maintenance

reply »


Feeder maintenance program | 17 November, 2009

Hi! I think you need some professional help to develop your Electronics Engineering. If you need it, just visit . You will find there thousands of great Mechanical Engineers who are really very helpful. You will get some extra facilities if you use this unique ' TURBOCIRCUITS' coupon word . Have a very nice time bye

reply »

SMT Custom Nozzles

Software for SMT