Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.

AP25 HiE

Views: 2152


AP25 HiE | 28 October, 2009

Can anyone tell me the command I need to type to get into machine configuration in DOS MpM software? I want to change x/y/theta cal. settings to adjust for vision offset because I don't have the fixtures to do a calibration.

reply »



AP25 HiE | 19 November, 2009

We had some AP machines that are long gone but found this in an old doc. Hope this works for you.

Hit the “esc” key to get to a dos prompt

Type “edit ap.opt”

Make changes.

Save and exit.

Reboot machine

Good luck

reply »

PCB Rework / Repair Services

Rework Training Materials