Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


HS60

Views: 2095

#60140

HS60 | 20 October, 2009

m/c error 3564 raceway monitoring triggered-gantry 3. In the help menu it says topic does not existed. Anybody has any idea what this error code mean? This is siemens hs60.

reply »

#60142

HS60 | 20 October, 2009

Seth,

From the Siemens technical information document:

Raceway monitoring detects incorrect positioning of the Z axis with respect to the raceway during motion of the star. This is done by monitoring the current drawn by the Z axis while the star is turning. If the current exceeds a particular value, the following error message is issued: "3564 Raceway monitoring triggered" This incorrect position can lead to early damage of the raceway. If raceway monitoring is triggered, a reference run is automatically carried out after the board has been completed. This can compensate for the incorrect position of the Z axis. If raceway monitoring constantly triggers, however, this indicates permanent incorrect positioning of the Z axis. The following are possible causes: • Incorrect setting of the top Z limit stop (see TI 10C06014) • Incorrect setting for the P gain or tacho of the Z servo • Belt tension of the Z axis belt too low (280 Hz ± 10Hz) • Faulty Z axis motor • Faulty servo card • Previously damaged raceway or Z axis aperture • Damaged Z axis guide

Raceway monitoring is an aid to the operator or service engineer in order to take preventive action to avoid damage to the raceway and the Z axis guide.

This should point you in the right direction.

Lloyd

reply »

#60144

HS60 | 20 October, 2009

Thank you very much for your information, well said. As of right now I am not using this gantry until I can resolve this issue in a timely manner to prevent it from costly repair. Thanks again for the info.

reply »

Electronics Equipment Consignment

PCB Cleaning