Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


share the DFX Design Guideline

Views: 1533

#60047

share the DFX Design Guideline | 5 October, 2009

Hello we'll share DFX Design Guideline as attached i hope dicuss with you MSN:liang.pung@hotmail.com

Attachments:

reply »

#60056

share the DFX Design Guideline | 6 October, 2009

As a start, consider running 'spell check' if you intend to keep the English portion.

reply »

#60102

share the DFX Design Guideline | 13 October, 2009

2.6.3 Test Pad Location Tolerances, third bullet. Why does Entek require different test point spacing than other surface finishes?

Page 55, top image is off the page, partially.

2.3.6 Depanelization of Arrays, 10th bullet [Breakaway Scoring] refers to "using a Lihr Hermann machine." What is this machine?

3.3.3 Thieving Pad Required for Wave Soldering Multi-leaded Devices, Table: "intersatitial" [2 places] should be "interstitial (staggered leads)"

3.4.6 SOICs [reflow]: Gives pads and pad layout for "wave" rather than reflow

reply »

Fluid Dispense Pump Integration

ii-feed SMD Intelligent Feeder