Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Philips Orion, was running perfectly, now won't recognize parts

Views: 2421

#59813

Philips Orion, was running perfectly, now won't recognize parts | 8 September, 2009

We have an Orion which has been running very well. We just started to run production of a board with NO changes from the last run about one month ago. Today, however, the vision system is not recognizing parts. The scan image on the monitor looks good. During parameter search, the part is recognized at the higher levels, and drops off as the light is lowered, all fine, then when you re-scan based on this optomized information the parameter test fails. This is on most if not all components. Any suggestions on trouble shooting this?

reply »

#59814

Philips Orion, was running perfectly, now won't recognize parts | 8 September, 2009

Not familiar with Philips machines but have had similar problem: If Philips uses fiber optics and halogen bulbs for lighting in the vision system, try installing a new bulb.

reply »

#59818

Philips Orion, was running perfectly, now won't recognize parts | 9 September, 2009

have you try to adjust lighting level . are there any object over the camera??? try to clean the camera len and adjust focus, see any help.

reply »

Used PCB Equipment - ECM

Used PCB Equipment - AdoptSMT