Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


X out marking

Views: 4058

#59551

X out marking | 18 August, 2009

Is there a standard (such as IPC) or common industry practice in regards with x-out marking on rejected boards of a panel?

Do board shops have to X-out both sides of the rejected board, or one side? If the answer is one side, which side should be marked?

reply »

#59552

X out marking | 18 August, 2009

There is no standard. You need to decide when you want the cost of bad boards applied to your product cost.

Search the fine SMTnet Archives for previous discussions, like: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=20871

reply »

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域

SMT Equipment