Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


CS-400D Manuals

Views: 2360

#58717

CS-400D Manuals | 3 May, 2009

I just bought a used Contact Systems CS-400D, and it does not have manuals. Does anybody have an extra set? Also, I haven't seen the machine yet, but I am wondering about getting PC software to do the programming and off-line programming.

Who is a good resource for these things. If it doesn't work, I might need some help.

Thanks,

Jon

reply »

#58718

CS-400D Manuals | 3 May, 2009

Get in touch with Bob see below he is the best in the bussiness. Robert L Tomaselli Magellan Service Corporation 1 Jacks Hill Road Unit 1F Oxford, CT 06478 (203)888 4919 FX (203)888 4916

reply »

#58748

CS-400D Manuals | 7 May, 2009

Bob has been very helpful so far. He was very reasonable on the price for the manual too. I think I'll have this thing in production by Monday Morning!

So far I've replaced the 5V Power Supply, re-aligned the X and Y, and re-laminated the table top. More work that I wanted to do, but not that many hours so far.

reply »

#58752

CS-400D Manuals | 8 May, 2009

Ive been working with Bob for many years. He is a great guy and will do anything to help you. We also bought a 400D from him and have had no issues with it. Make sure you have him come in and do the PM.

reply »

#58800

CS-400D Manuals | 13 May, 2009

Does anybody have any recommended Clinch/Length values for:

1/4W Resistor 1N4007 Diodes 3W Resitors (A bit bigger than 1N4007 leads).

Thanks,

Jon

reply »

#58826

CS-400D Manuals | 15 May, 2009

I use a clinch of 5 and a length of 3 for 1/4w and thicker leg diodes probably a 7 and 5. You really just have to play with the machine it figure out what works best for your application.

reply »

vacuum tweezers - manual pcb assembly

Flying Probe Tester