Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Triton SMT IV washer troubleshooting

Views: 1401


MM

#58590

Triton SMT IV washer troubleshooting | 14 April, 2009

Could anyone tell me why the prewash tank will run for awhile and then the tank will fill and over fill. I am not too aware of the machine and trying to help. It looks like there are 3 different level switches. It looks they work properly for about 5 minutes then the water turns back on and stays running and overfills the tank. Does anyone have any suggestions?

reply »

#58616

Triton SMT IV washer troubleshooting | 16 April, 2009

You might try checking to see if the float switches are actually lifting up with the water level, I have seen them get stuck in the open position. Also check to see that the solenoid valve is actually sealing off (closed)

reply »

Boundary Scan