Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Who is the Mydata TP series expert ?

Views: 853

#57161

Who is the Mydata TP series expert ? | 4 November, 2008

My TP-11 is not getting enough juice to the upper Z-lock to pull it out of the way. Its not the locks.. I put new ones in and I get the same thing.

Its like I am not getting enough voltage from the XWB. Has anyone seen this before ?

reply »

#57162

Who is the Mydata TP series expert ? | 4 November, 2008

SrTech,

I do not know Mydata's but I had a problem with a solenoid for a nozzle changer that just didn't seem to be strong enough. Finally found a partial break in the wire. I seemed like this acted a resistance to the current flow and did not allow the solenoid to operate. By the way it appeared good with an ohmmeter but the voltage was very low at the solenoid when energized but the driver card had the proper voltage at its output.

Jerry

reply »

SMT Custom Nozzles

Plasma Prior to Conformal Coating