Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Dek-265 no power

Views: 1547


GEM

#54525

Dek-265 no power | 30 April, 2008

DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that little green box. look like there wasn't any power going in to the transformer. any idea ??????? thanks

reply »

#54527

Dek-265 no power | 30 April, 2008

Is the green box on top of the transformer? If so you can by-pass it.

reply »


GEM

#54528

Dek-265 no power | 30 April, 2008

Yes, it is. there's a heat sensor under of 4 resister,look like it open now.I'm thinking to make a jumper right there to see it can power up the machine.(this's a little green box on top of the transformer)

reply »

#54530

Dek-265 no power | 30 April, 2008

I've done it in the past. By-pass it and you'll be back in production. Make sure your power is off.

reply »

#54532

Dek-265 no power | 30 April, 2008

You need switch out the cognex vision card.

reply »

#54535

Dek-265 no power | 30 April, 2008

No, you don't.

reply »


GEM

#54536

Dek-265 no power | 30 April, 2008

It back running now, after shut it off over night, it power back up,look like the heat sensor under of 4 resistors is start getting bad.But i'll by pass it, if it happen again. Thank you for your in put.

reply »

Reflow Oven

HeatShield Gel- thermal PCB shield during reflow