Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


How much air flow is required for an Omni Flow 5 oven?

Views: 1476

#53668

How much air flow is required for an Omni Flow 5 oven? | 15 February, 2008

We are looking at an Omni Flow 5 Oven and do not have much information on it. We do know it has a 3" cabinet vent and a 6" vent near the center on the top. If anyone has knowledge of this oven, and has any suggestions or info, we would appreciate it. Thanks in advance, RK

reply »

#53673

How much air flow is required for an Omni Flow 5 oven? | 15 February, 2008

This is from the OmniFlo 5 Engineering data sheet:

EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Water gauge pressure drop: 1.0� (25 mm) for each 4� (102 mm) stack on the machine INERT ATMOSPHERE OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Water gauge pressure drop: 0.5� (12 mm) for each 4� (102 mm) stack on the machine Note: All specified exhaust requirements listed above are minimum values. The external exhaust connections are the same for both standard air and inert atmosphere machines. The internal connections to the lip vents are configured according to the air or inert atmosphere machine configuration.

reply »

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域