Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Dek-265

Views: 1818


GEM

#51736

Dek-265 | 11 September, 2007

Can not boot up . during down load vision system,an error come up VISION HARDWARE ERROR FAIL IN FUNCTION 1 STATE 2,VP STATE 0X28 ERR 0 any one know what's wrong with it.. thank you.

reply »

#51744

Dek-265 | 11 September, 2007

Sounds like the Cognex vision processor in the PC is bad. There is really nothing you can do but buy a new one. These typically run between 5k to 9k.

Good luck

reply »


GEM

#51757

Dek-265 | 12 September, 2007

thanks Chris .

reply »


aj

#51758

Dek-265 | 12 September, 2007

do you have another dek machine in the factory ? if you do start swapping out cards that are related to the vision

aj...

reply »

#51763

Dek-265 | 12 September, 2007

Probably not it, but there are a couple of fuses on the card. Also try re-seating the card in the computer.

reply »

ii-feed SMD Intelligent Feeder

Used PCB Equipment - ECM