Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Electrovert - MiniPak 300, FDC 450 controls, setting Threshold

Views: 3751

#50468

Electrovert - MiniPak 300, FDC 450 controls, setting Threshold | 31 May, 2007

Revelation Industries has an Electrovert MPK1-24774. The manual lacks sufficient information to troubleshoot and fix this problem:

Reference: Minipack 300 Wavesoldering System 1986 edition, pg, 18, fluxer, Threshold adjustment. After completing the field calibration for FDC-450, I followed the instructions on adjusting the Threshold setting. With the density value set a .875, I turned the set screw to the right 14 times from zero and to the left 14 times from zero, and the value of the specific gravity on the LED display never changed. At no time did the LED "flux" nor the LED "Thinner" turn on. They should have turned on or off by adjusting the set screw CW or CCW. What do I do to trouble shoot the problem and fix it? Does anyone know of awebsite for which instructions and manuals are stored in digital form for this machine?

Jim Miller jamesm@revelationindustries.com Jim Miller Revelation Inudstries, Inc. jamesm@revelationindustries.com

reply »


G S

#50469

Electrovert - MiniPak 300, FDC 450 controls, setting Threshold | 31 May, 2007

I dont know if this helps, but the FDC was made by ECD controls. You might contact them

reply »

#50510

Electrovert - MiniPak 300, FDC 450 controls, setting Threshold | 5 June, 2007

Try ECD tech support at 800-323-4548

ECD 4287-B SE International Way Milwaukie, Oregon 97222-8825 U.S.A Telephone: +1 503 659 6100 or +1 800 323 4548 Fax: +1 503 659 4422 E-Mail: ecd@ecd.com

reply »

Flying Probe Tester

Reflow Ovens thermal process improvement