Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Change-over time savers.

Views: 1295

#50331

Change-over time savers. | 22 May, 2007

Hi. We have changed our produktion from high volume to medium/low and have to start hunting change-over time. We have a lot of products with two sides and the settings of pins in the DEK 265 and Fuji QP242 machines when running b-side takes to long time. We have tried the Formflex from DEK that didn't work and are now using Gridlock, that do work, in one DEK. Those Gridlock can be fitted into the Fuji QP:s as well but there is a problem, the price... Do any of you have another solution or products for this that you can recommend for us?

Regards Joakim.

reply »

#50333

Change-over time savers. | 22 May, 2007

Hi Joakim,

I do not know the QP242 table, but on our GP-341, CP-IV-2 and IP-III we make a plate from plexiglass with milled holes to show where the supports go for each board. This is not as fast as the Gridlock but does not cost nearly as much.

Jerry

reply »

BGA Rework Services

 Reflow System