Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Resistor height

Views: 983

Jim Mills

#50158

Resistor height | 9 May, 2007

Greetings

Tried to search past threads without an answer. I have a resistor that just fits the between pads. Some of the resisitor were installed without the termnation sitting on the pad and are infact sitting on solder a good .020 to .025 above the pad. The solder meets the IPC for fillet height. Looked in IPC 610D for clarification height wise, but could not find any.

Does anyone out there know the industry spec. for a resistor termination not sitting on the pad but soldered above the pad?

Thanks

Jim

reply »

Used SMT

SMT in-printer dispensing