Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


IPC Standard for mechanical Hardware

Views: 3071

Sundaram kumaravelu

#49233

IPC Standard for mechanical Hardware | 23 April, 2007

Hello,

Does any one know of an IPC standard for mechanical hardware. For eg we had connectors from our supplier which had 4 or more radial splits in screw mounting flange and the plating finish was not uniform on many of them. I am trying to get infomation on standards against which we could inspect hardwares. I appreciate any help in this regard.

Thanks, Sundaram

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

#49265

IPC Standard for mechanical Hardware | 24 April, 2007

IPC-A-610D, 6.2.2 Swaged Hardware � Flared Flange

reply »

#49277

IPC Standard for mechanical Hardware | 25 April, 2007

I don't know of any standards that apply to hardware at the component level. I would think, though, that unless the spec. sheet for the component specifies cracks there shouldn't be any.

reply »

Sundaram Kumaravelu

#49278

IPC Standard for mechanical Hardware | 25 April, 2007

Thanks for your response

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

Used SMT Equipment

reflow oven profiler