Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
I realize this is a bit off topic but looking at some of the...
- Feb 22, 2007
Fuji CP IV specs (ball screw) | 22 February, 2007
I realize this is a bit off topic but looking at some of the discussion. I expect someone might be able to help.
Looking at CP IV ball screws 120" and searched the world over for specs.
Lead Outer Diameter TPI backlash resolution typical wear on chip shooter ball screws, utilization Reasonable IPM
Anything would be helpful
Building multi purpose CNC. Used to work in component distribution so
© 1995-2016 SMTnet
Who are SMTnet visitors?
Become a member now and receive the value and benefits of membership.