Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Please Help

Views: 640

Stano

#44067

Please Help | 20 September, 2006

I have problem with Panasert MV2VB. After activation machine start up Windows NT normally, well near end initialization displayed message: MMI initial check - Symbol 1 - 0 error. After initialization finish and Power On machine is dispalyed Self diagnostic display where is Inteligent card dispalyed error code E1. And anfter is dispalyed two ways, MMI monitoring and Install control software.I did change MMI controller, control panel front, control panel rear, well it do not help me. Please help me anybody. My email: hvizdos@mavsk.sk

reply »

Lead Free Wave Solder - 1 Click SMT

PCB Rework / Repair Services