Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


PCB open trace repair

Views: 3184

spari77

#43221

PCB open trace repair | 8 August, 2006

hi, can anyone share experience on PCB open trace repair? we have some data that indicates that this repair is high risk and really very dependant on repairer skills. It may also cause reliability issue for trace repair. please advice.

This message was posted Add this forum to your site! Click to learn more. the Electronics Forum @

reply »

Chunks

#43224

PCB open trace repair | 8 August, 2006

Since we build produt and co not repair, we send our damaged boards to a place that specializes in board repair.

reply »


RDR

#43249

PCB open trace repair | 9 August, 2006

Trace repair is dependent upon the operator. A highly skilled operator can repair a trace with no adverse effects on assembly. IPC has a manual on reapir methods and there associated risk relating to reliabilty. I wil try and find number when time permits for you or you can look for yourself at ipc.org

Russ

reply »

Board House

#43260

PCB open trace repair | 9 August, 2006

Our Manufacturing policy regarding welds is as follows.

1) Inner layers - depends on Core thickness and line width. Our shop will not do any welding on core thickness less then 5 mils. or line width less then 5 mil. Good AOI practices reduce the amount of opens on inner layers. (Scanning production Artwork is the Key or scanning first pieces prior to etching).

The major falure that will happen on Internal welds is caused by handeling after the weld is completed. (rubbing)

Once the weld is completed and the boards have been laminated together the weld is as strong as the origanal circuit.

2) Outer Layers are typically not done just for cosmetic reasons. but if they are done a thin coat of epoxy will be placed over them and then soldermask touched up to conceal. Again 5 mils circuits should be the Min.

Regards,

Board House

reply »

PCB Soldering Tools

Heller Industries Mark 5获得了 2015年中国SMT远见奖 - 回焊炉领域