Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


AP20 Printer issue

Views: 1081

Geo E

#41129

AP20 Printer issue | 21 April, 2006

I am trying to find out if the AP20 MPM Printer is SMEMA ready or was it an Add-on, I can not find any documentation in the manual as to where the Smema is to be connected.Or does the diagrams show any smema hook ups. Any help would be appreciated.

reply »

#41134

AP20 Printer issue | 21 April, 2006

SMEMA didn't exist when this printer was in production.....at least not in the early years of production.

reply »

#41136

AP20 Printer issue | 21 April, 2006

The snema connecters are located behind the front cover, and to the left of the small power supply. The connecters are up side down. The front one is the left side and the second one back id the right side. Left is normaly the upstream and the right is the down stream. Both of these are in the electrical drawings. harry

reply »

SMT in-printer dispensing

HeatShield Gel- thermal PCB shield during reflow