Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Views: 1426



msf | 20 April, 2006

we are using panasert msf machine we encounter there is fine pitch alignment problem this is not happen every board.

reply »



msf | 20 April, 2006

Well i wouldn't run every board then!!!!

okay seriously, All bad parts off the same each time or are they "all over the place"

Check your mount height, you may have sagging or warped boards or just bad part height

reply »



msf | 2 May, 2006

are u using 3d / 2d camera 1) machine setup support pin must be strong. 2) machine part libary must be perfect and good condition. 3) using the right nozzle. 4) check the board clamp must be clamp fully. 5) and we can also try doit head and camera calibration.

thks .......

reply »

Reflow Ovens thermal process improvement

Used PCBA Equipment