How can we force Fuji IP-1 to re-scan fiducial marks?

Subscribe to Thread

We just got our used Fuji IP-1 working well. Sometimes duri... - Feb 17, 2006 by Bert

Bert, After pressing F1 for auto operations but before pres... - Feb 17, 2006 by jdengler

Thanks Jerry - I'll try it on Monday. Cheers, Bert ... - Feb 17, 2006 by Bert

Bert

#39778

How can we force Fuji IP-1 to re-scan fiducial marks? | 17 February, 2006

We just got our used Fuji IP-1 working well. Sometimes during testing of a new program/pcb we like to stop the run and re-start with a clean board. When we make the IP-1 eject the unfinished pcb and start with a new pcb the IP-1 does not scan the fiducials and just continues from where it left off the last pcb. Obviously without scanning the fiducials the accuracy is not as good. The only way we found so far to get the IP-1 to re-scan the fiducials and start the pcb from the beginning is to change the program to another and change back to the original program.

Is there a simple method to force the IP-1 to start from scratch using the front panel keypad?

Regards,

Bert

reply »

jdengler

#39784

How can we force Fuji IP-1 to re-scan fiducial marks? | 17 February, 2006

Bert, After pressing F1 for auto operations but before pressing start, press F4 SQ.N. This will ask for a sequence number. Press 1 on the number pad then CR. This will start the program a sequence #1. Then press start and all is well. Jerry

reply »

Bert

#39797

How can we force Fuji IP-1 to re-scan fiducial marks? | 17 February, 2006

Thanks Jerry - I'll try it on Monday.

Cheers,

Bert

reply »