Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 3103
Hi all, I want to know the possible causes of poor paste re... - Jan 09, 2006 by Abhi
Squeegee pressure or height, snap off, the age and/or condit... - Jan 09, 2006 by Steve Thomas
Hi, If the stencil was not cleaned well from the previous... - Jan 09, 2006 by Grant
Dear Grant, Thank you for the reply. It is really a valid r... - Jan 09, 2006 by
I assume you're using a no clean Pb/Sn paste, with a metal s... - Jan 09, 2006 by Joseph_Cumbey
Take a look at the boards, too. Could the HASL be different ... - Jan 09, 2006 by Steve Thomas
"Poor release" (paste hanging-up in the stencil holes) could... - Jan 09, 2006 by davef