Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
We have a new Heller 1809 EXL reflow oven and when we run ME... - Jun 29, 2005 by
Start from this: - check the air flow speed, if too muc... - Jun 29, 2005 by
investigate the part ,maybe mositure could get into the part... - Jun 29, 2005 by hailongx
Can you run the board on the other side of the oven??? Can y... - Jun 30, 2005 by
Is this happending consistently with every board? I gues... - Jun 30, 2005 by
Ryan, I have never seen an oven "blow" parts off the pads. ... - Jun 30, 2005 by Sr. Tech
i've seen ovens blow the parts off of boards, but only the o... - Jun 30, 2005 by
Its been my experience that a "dot" of glue on the center of... - Jun 30, 2005 by SuMoTe
I'm not familiar with this particular oven, but have seen th... - Jun 30, 2005 by K
I had the same incident before, and like GS pointed out, the... - Jun 30, 2005 by
1. Migrate to horse-shoe pad design. 2. Verify your furna... - Jun 30, 2005 by
I had similar issue with our new 1809 Heller Oven recently. ... - Jul 01, 2005 by vikkaraja
We had this happen in a Heller 1808 oven when we placed Tant... - Jul 01, 2005 by
I too experience it too component being blown out of the pad... - Jul 14, 2005 by pyramus
Ryan