Parts from gerber

Subscribe to Thread

I'm looking for a simple low cost tool to get part position ... - Sep 06, 2003 by

Hi I think each programmer can write you such a programm. Bu... - Sep 09, 2003 by Evtimov

I believe you asked exactly the same answer a couple of mont... - Sep 09, 2003 by

I did, but none of the answers really worked. But I've check... - Sep 11, 2003 by

GC-Place works well. I used it to generate GenCAD files f... - Sep 12, 2003 by

dave

#25658

Parts from gerber | 6 September, 2003

I'm looking for a simple low cost tool to get part position and rotation info from gerber- is there anything out there?

This message was posted via the Electronics Forum @

reply »

Evtimov

#25673

Parts from gerber | 9 September, 2003

Hi I think each programmer can write you such a programm. But about rotation I believe it's not possible.

reply »

Duane

#25678

Parts from gerber | 9 September, 2003

I believe you asked exactly the same answer a couple of months ago: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=6296&#Message25158

I hope you get better answers this time, but probably more of the same.

reply »

Dave

#25702

Parts from gerber | 11 September, 2003

I did, but none of the answers really worked. But I've checked gerbergrab again, and it's now free (maybe they couldn't get anything for it!). I've tried it, and it actually works quite well, probably all I need for now, but any other suggestions welcome.

This message was posted via the Electronics Forum @

reply »

Dominador Sagun

#25724

Parts from gerber | 12 September, 2003

GC-Place works well.

I used it to generate GenCAD files for CIMBridge.

reply »