Failure analysis

Subscribe to Thread

Hi I uploaded the photos ... - May 22, 2003 by

What solder are you using ? what is the peak temeprature ? ... - May 22, 2003 by Kris

Henry are you thinking ball peen hammer? Initial question... - May 22, 2003 by davef

Henry Lee

#24562

Failure analysis | 22 May, 2003

Hi I uploaded the photos http://hk.photos.yahoo.com/ee02lyk of the failure samples. The chip-cut and pin-hole were found after the manufacturing process. I initially suspect the crack happened during the reflow process.However, our factory analysis does not seems to agree. I need to know the possible root cause of failure.

So, I really hope that you can share your experience

Thanks in advance for any assistance

Henry Lee Hong Kong SAR

reply »

Kris

#24567

Failure analysis | 22 May, 2003

What solder are you using ? what is the peak temeprature ?

Are you using the right tools to place these components ?

reply »

davef

#24568