Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Voids in grounding pad of RF PCB

#20979

Voids in grounding pad of RF PCB | 30 July, 2002

Hi Anyone has experience in manufacturing RF PCB and encounter voids on the grounding pads? The grounding pad is covered by the a big component. Question is does voids in the solder joint affect the RF operation?

reply »

JohnW

#21037

Voids in grounding pad of RF PCB | 2 August, 2002

Richard,

your asking a multi million dollar question that in my own opinion no one can give you the right answer since no one really knows. hence I think the lack of answers to your question....thought there would be more people willing to propose a thought or two. there was a question on the SMART Group forum in the uk about voiding in a BGA within an RF system. Basically most people are saying it's not much of a problem since the current flows over the surface and not through the joint. Now I'm just a lowly process guy so I don't know about all that but from a mechanical point of view the void can be a good thing as it'll act as a stress reliever and also inhibit crack propogation in the system. I couldn't tell you if the void would heat up more than the rest of the joint as it's a test again that still need's to be done, if you can loan me an thermal imaging camera I could tell you right enough.

JohnW

reply »

SMT spare parts - Qinyi Electronics

Reflow Oven