Tenryu 5500, "x over run"

Subscribe to Thread

Hi, My Tenryu 5500 is showing "X OVERRUN" Error while perfo... - May 21, 2002 by SMT Service Centre (India) Pvt. Ltd.

without knowing your machine, I guess the axis does not find... - May 21, 2002 by Stefan Witte

did you fix your x overun problem? ... - Aug 28, 2002 by dgjjr

SMT Service Centre (India) Pvt. Ltd.

#19992

Tenryu 5500, "x over run" | 21 May, 2002

Hi, My Tenryu 5500 is showing "X OVERRUN" Error while performing Origin. Can anybody tell the probable reason.

thankyou.

Priyaranjan

reply »

Stefan Witte

#19993

Tenryu 5500, | 21 May, 2002

without knowing your machine, I guess the axis does not find the zero pulse. You may have to re-place the incremental or linear encoder for the X-axis. Some vendors use proximity switches for a zero pulse which could be defective. If the axis stops in its home position but drifts into the limit switch thereafter, your servo board may be blamed. For general trouble shooting look at my site http://www.geocities.com/stefwitt/trouble.html

reply »

dgjjr

#21346

Tenryu 5500, | 28 August, 2002

did you fix your x overun problem?

reply »