Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Reparing 0201 components on PCB-boards

peternor

#18143

Reparing 0201 components on PCB-boards | 12 November, 2001

Is there anyone who can give me a tip of how I can repair 0201 components on a PCB-board? I would also like to know if there are any special tools for that operation!

Thanks Peter

reply »


CAL

#18148

Reparing 0201 components on PCB-boards | 12 November, 2001

A real small soldering iron, a real steady hand, a qualified solderer. Soldering skill set is key. Iwould sugest a Micro scope. Sonora Mfg (I am sure there are others)has an infinate scope that you can solder under. aside from that....skill set.

reply »

#18152

Reparing 0201 components on PCB-boards | 12 November, 2001

Listen. Reworking 0201 is too expensive.

Here�s watt yado � * Cut the lil� suka between the pads on the board using side cutters. * Flick each piece from its pad, after melting the solder with a standard soldering iron. * Solder the terminations of a new component to the pads using a standard iron with standard practices.

reply »

ianchan

#18161

Reparing 0201 components on PCB-boards | 12 November, 2001

Am abit confused here, so suggestion is not to manual rework solder the 0201, and rather to cut em' out, with the cut shear applied at the end-terminals?

elaborate pls? thanks

reply »

Michael Parker

#18165

Reparing 0201 components on PCB-boards | 13 November, 2001

Maybe Prof. Whoopee will have to take out the 3 D BB and draw us a picture.

reply »

ICT Total SMT line Provider

Sell Your Used SMT & Test Equipment