Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


reflowing double sided SMT

Mark Belec

#9600

reflowing double sided SMT | 14 September, 1999

I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts.

reply »

#9601

Re: reflowing double sided SMT | 15 September, 1999

| I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | Hello, you can get some insight by typing in double sided boards at the search window. I run 2 sided often and usually just profile the second pass. You want to assemble the side with the lower mass first. The surface tension will hold components on. Hope this helps

wayne sanita

reply »

joel cruz

#9602

Re: reflowing double sided SMT | 23 September, 1999

| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double sided boards at the search window. I run 2 sided often and usually just profile the second pass. You want to assemble the side with the lower mass first. The surface tension will hold components on. Hope this helps | | wayne sanita | | Hello, Other tip for doubled reflowing are than the profile for the second reflow in the reflow oven in the teperatures of bottom are low than top, whit this your components of the firts reflow don`t have high temperature two times and you are sure than the components of the firts reflow is not missing.

I hope than you help me whit this question

�How I calibrated the air for the reflow oven, because I have component missing in my firts reflow for this? | |

reply »

joel cruz

#9603

Re: reflowing double sided SMT | 23 September, 1999

| | I'm looking for some good articles on reflowing of double sided SMT boards. I'd like to come up with a process for low volume prototyping, but need to understand the do's and don'ts. | | | Hello, | you can get some insight by typing in double sided boards at the search window. I run 2 sided often and usually just profile the second pass. You want to assemble the side with the lower mass first. The surface tension will hold components on. Hope this helps | | wayne sanita | | Hello, Other tip for doubled reflowing are than the profile for the second reflow in the reflow oven in the teperatures of bottom are low than top, whit this your components of the firts reflow don`t have high temperature two times and you are sure than the components of the firts reflow is not missing.

I hope than you help me whit this question

�How I calibrated the air for the reflow oven, because I have component missing in my firts reflow for this? | |

reply »

Void Free Reflow Soldering

Reflow Oven