DEK Galaxy - removing Heavy Pallet Rails option via software

Subscribe to Thread

I have an issue on my DEK Galaxy printer. The problem is I ... - Jun 12, 2018 by paul_bmc

I don't recall a "Heavy Pallet Rails" option in software; I ... - Jun 12, 2018 by DEKHEAD

paul_bmc

#80533

DEK Galaxy - removing Heavy Pallet Rails option via software | 12 June, 2018

I have an issue on my DEK Galaxy printer. The problem is I need to use the hard PCB stop rather than the sensor stop. The printer use to have Heavy Pallet Rails installed prior to me purchasing the machine. The 3rd party removed the rails and replaced with standard rails. The problem is the machine software still thinks the heavy rails are installed so it will not allow me to use the pneumatic PCB stopper. I am not sure if this is something that is configured under Machine Setup in Diagnostics or somewhere else. If under machine setup - diagnostics, it requires a password that I do not have.

reply »

DEKHEAD

#80535

DEK Galaxy - removing Heavy Pallet Rails option via software | 12 June, 2018

I don't recall a "Heavy Pallet Rails" option in software; I believe you need to change the Remote Board Stop to "Not Fitted" and move the pneumatic and electrical (BSK6)connections to correspond with the camera mounted board stop. Pretty well detailed in Rising Table chapter of Tech Ref Manual.

reply »