Mirae Mx series, parameters to accelerate the heads in Z.

Subscribe to Thread

I work with lines MX200l and MX 200LP, one of them is with c... - Mar 29, 2018 by Electronics

In Production Monitor....there is Utility and Axis speed. Ma... - Mar 30, 2018 by bobpan

Hello Bobpan, Thank you very much for replying, Actually th... - Apr 03, 2018 by Electronics

mrcjet ... - Apr 03, 2018 by bobpan

Electronics

#80132

Mirae Mx series, parameters to accelerate the heads in Z. | 29 March, 2018

I work with lines MX200l and MX 200LP, one of them is with camera analogue the others with digital cameras, the oldest one (analogue camera) is faster than the others, but there is a line that must have a delay in the pick and place, someone knows where can I configure the parameters to be faster?

reply »

bobpan

#80134

Mirae Mx series, parameters to accelerate the heads in Z. | 30 March, 2018

In Production Monitor....there is Utility and Axis speed. Make sure the z-axis are set to 100%. I would also check to make sure in your component information that you dont have your parts slowed down or have long place and/or pick delays.

good luck

reply »

Electronics

#80153

Mirae Mx series, parameters to accelerate the heads in Z. | 3 April, 2018

Hello Bobpan, Thank you very much for replying, Actually there is the utility of Axis speed, but it asks for a password that I do not have, compliments.

reply »

bobpan

#80154

Mirae Mx series, parameters to accelerate the heads in Z. | 3 April, 2018

mrcjet

reply »