Printed Circuit Board Assembly & PCB Design SMT Electronics Assembly Manufacturing Forum

Printed Circuit Board Assembly & PCB Design Forum

SMT electronics assembly manufacturing forum.


Siemens HS180 Vision System placing compinents with PCB

Views: 750

#79623

Siemens HS180 Vision System placing compinents with PCB | 16 January, 2018

Hello,

i try to programm my vision system from our HS180 to place a Radio-Module (RN2483 from Microchip).

On the Visionsystem, the Module are very bright! So i cant teach the leads from the module. I tryed to teach only measuring outline, but sometimes it recognised a complete different area.

The Module have 26.67mm long and 17.78mm wide. The pins of the module cant seen correctly in the vision system, because its gold plated and the pcb solder resist have in the IR the same reflection.

Here is the vision-side of this modle: https://www.hackables.cc/62-thickbox_default/transceiver-rn2483a.jpg

best regards and thanks Alex

reply »

#79624

Siemens HS180 Vision System placing compinents with PCB | 16 January, 2018

There is no reason why you can't see these leads clear. Isn't there any way you can play with the lighting? I used to have Siemens machines and I want to say that it was possible. Go on the machine, start editing this shape code and find where you can change the lighting.

reply »

#79628

Siemens HS180 Vision System placing compinents with PCB | 17 January, 2018

Hi Evtimov,

no, i have no possibilities to change the Light. My Camera knows only on and off.

The PCB-Solder resist looks in that IR-Light whyte like the CE-Symbol of the picture i post in my first message. The Pins with gold looks the same. Its an the Picture only one square part. I tried to mesure the outline, dont work! I the Module is a little bit out of place, the ICOS mesure a complete wrong position.

reply »

#79630

Siemens HS180 Vision System placing compinents with PCB | 17 January, 2018

Yeah,

your machines are probably even older generation. I can tell you that what you can see is always more clear than what the machine can see(worked with 10 brands and probably 30 models). If you don't have good lighting and camera, some parts just won't make it. May it is time for an upgrade!? :) Good luck!

reply »

SMT Custom Nozzles

StikNPeel™ Rework Stencils