Printed Circuit Board Assembly & PCB Design Forum
SMT electronics assembly manufacturing forum.
Views: 12855
Anyone know how to use AutoProgram 5.32 for the Quad IVc ass... - Apr 01, 2013 by m-aide
Sounds like you need to be at a different level of operator.... - Apr 01, 2013 by MM
AutoProgram has no password. I did a fresh install of AutoPr... - Apr 01, 2013 by m-aide
In order to create a new part you must first select one of t... - Apr 01, 2013 by RLM
Yes! Thank you. That was not intuitively obvious, nor did th... - Apr 01, 2013 by m-aide
Have you entered your machine configuration into Autoprogrem... - Apr 02, 2013 by RLM
I have entered my machine configuration as much as I can fig... - Apr 02, 2013 by m-aide
It has been years since I used autoprogram. But I believe y... - Apr 02, 2013 by MM
That makes some sense. By knowing the coordinates of the lef... - Apr 02, 2013 by m-aide
The manuals will not teach you how to use Autoprogram but th... - Apr 03, 2013 by RLM
OK, so I think I have figured out the machine configuration ... - Apr 03, 2013 by m-aide
Autoprogram will use whatever tape feeder width is defined f... - Apr 04, 2013 by RLM
I think I'm slowly figuring out vibratory feeders. Who would... - Apr 04, 2013 by m-aide
I've never seen one but i've been told that there is a 2 tie... - Apr 05, 2013 by RLM
I have a clue about Feeder Optimization returning the error:... - Apr 05, 2013 by m-aide
I have no idea why this limitation would be programmed in. L... - Apr 05, 2013 by RLM
I cheated on the escapement length for the SOLIC plate and g... - Apr 05, 2013 by m-aide
What operating system are you using ? I have found that you ... - Apr 08, 2013 by RLM
I have set Maximum Sequence Steps Per Program Segment to 450... - Apr 08, 2013 by m-aide
I copied a program to a floppy and compared that to the file... - Apr 08, 2013 by RLM
So my board is called 850152, and is in a folder called BRD2... - Apr 08, 2013 by m-aide
I made a new program today that will run on 2 machines and m... - Apr 09, 2013 by RLM
I followed your instructions and did NOT select the option t... - Apr 10, 2013 by m-aide
I have never run across that error message before. Does the ... - Apr 11, 2013 by RLM
Some progress, now stuck again. I can now generate a pick an... - Apr 12, 2013 by m-aide
I have not been on this site for a while but I was reading y... - Apr 17, 2013 by gosswald
To use 2 heads in autoprogram.....each one should be defined... - Apr 18, 2013 by bobpan